« previous next »
Pages: [1]   Go Down

Introduction and a Crossover Question

0 Members and 1 Guest are viewing this topic. Read 631 times.

Chevy2410

  • Jr. Member
  • Posts: 4
Introduction and a Crossover Question
« on: 2 Feb 2021, 01:50 am »
Hi all,

I'm new to Audio Circle and DIY speakers to. Some years ago I built a DIY 3 channel chipamp and I'm still using it today. Now I've got the DIY speaker itch, so after some researching and watching videos I decided to purchase GR Researches X-LS Encores to start. If all goes well I may move to do an open baffle sub. Anyway, after receiving my order I started putting together the crossover. I'm pretty sure it's correct, but would like someone to look it over before I solder it all up. I went full out with all the upgrades. There's a 1uf SoniCap under the green Lynk resistor a little hard to see it.

Thanks for looking,
Chevy












 
Logged

Hobbsmeerkat

  • Industry Participant
  • Posts: 2731
Re: Introduction and a Crossover Question
« Reply #1 on: 2 Feb 2021, 03:12 am »
Welcome to AC! :thumb:
That's a really nice crossover too!
Logged

Chevy2410

  • Jr. Member
  • Posts: 4
Re: Introduction and a Crossover Question
« Reply #2 on: 2 Feb 2021, 11:08 pm »
Quote
Welcome to AC! :thumb:
That's a really nice crossover too!

Thanks Hobbs! I appreciate it. 8)
Logged

Chevy2410

  • Jr. Member
  • Posts: 4
Re: Introduction and a Crossover Question
« Reply #3 on: 2 Feb 2021, 11:34 pm »
Opps! Sorry guys I didn't see the crossover sticky.
Logged
Pages: [1]   Go Up
« previous next »