Hello all,
I recently installed a new cartridge (Dyna XV1s) on my Amadeus and I found that I could not raise the arm pillar high enough to obtain the proper VTA. The pillar would need to go above the range where its retaining screw will operate correctly.
There is a rather terse explanation in the Instruction Manual about how to fix that problem. In my version this is a note at the bottom of p. 13.
Here is how I interpret what is said there. I should pull out one of the two nylon tubes that are inserted into the golf ball and through which the nylon bridle that attaches the ball to the arm suspension enters the ball. Once that tube is pulled out, I should then insert an additional length of the bridle into the ball so as to shorten the portion that remains outside the ball. Then, when I will reinsert the nylon tube into its hole, the tube will somehow prevent the newly inserted segment from coming out. As a result, the bridle will be shorter and it will no longer be necessary to lift the pillar out of its normal range in order to get my correct VTA.
Can you tell me if my understanding is correct? I would not want to try applying an incorrectly understood procedure.
Thanks for your responses,
Pierre