Home
Circles
Gallery
Systems
Calendar
About/Help
Login
Register
Gallery
»
Browse gallery
»
Albums by toobluvr
»
DIY audio rack (work in progress)
Gallery
Browse gallery
Random albums
I'm Feeling lucky
Up to Albums by toobluvr
DIY audio rack (work in progress)
STEP 1: Bolt 8020 posts to underside of top shelf. Don't fully tighten yet.
Top shelf: countersunk bolt washer
Hardware to bolt top shelf into 8020 uprights, sourced from boltsdepot.com.
Butcher Block Table Tops: cut, sanded, stained and poly'd w 7 coats of semi-gloss ......WHEW, lotsa work!!! - top shelf: 46.5 x 19.5 x 1.75 lower shelves: 43 x 19.5 x 1.5
8020 Deluxe Leveling Foot to attach upright to floor. NOTE: I decided to not use these as the ball-in-cup design was overkill for my level floors. Instead I use Hex bolt and cover heads with felt disks to protect floors. $60 savings. - Any spike, leveller or furniture glide can be used here.
All shelves installed and spaced. I found it easiest to assemble the entire rack upside-down, on saw horses.
STEP 3: Attaching the lower shelves - First install the bottom shelf as described in other photo. Then slide it to the bottom of the posts and tighten. This forces posts to be straight, plumb and square over their entire length. Now tighten bolts countersunk into top shelf. Be sure to hold posts square. Starting with the lowest shelf first, the middle shelves are then installed individually in the same way as the bottom shelf. That is, by laying each one across the underside of the top shelf, spacing and lining up, and attaching hardware. Then slide each shelf into desired position and tighten the hardware. Rather than use a level, I just measured along the uprights and put pencil marks on the (4) uprights. By definition, this must be level. Once all middle shelves are installed, positioned and tightened, loosen bottom shelf and slide into the desired position, and tighten.
STEP 2: Attaching the bottom shelf. - Lay bottom shelf on underside of top shelf, space and line things up, and then attach hardware. Don't fully tighten.
Sliding inside corner bracket / T-nut assembly into T slot.
«
Prev
| Page 2 | (Next)
View slideshow