Work in Progress

Living room equipment and tweeks

The speakers are also Bi-Wired. This makes a big improvement in sound clearity. esspecially voice. They are secured using Monster Spade connectors	This is my DIY Subwoofer project. It has a 12 dual voice coil operated by my front stereo amplifier. It also doubles as a coffee table. The tiles get a high WAF	Because the Sub is heavy (Approx. 50lbs), I installed 6 wheels so I can move it around. The cork costers were used to isolave vibration from sub to floor	Rear suround Speakers. Cheap but located properly they sound acceptable. They are both mono directional. The lower speaker is covered in speaker fabric and is directed toward the rear wall. The upper speaker is tilted and directed towards the ceiling.
Well, here is my little master controller Zackari programming the macros into my One for all remote control

« Prev | Page 2 | (Next)