Treble & Midrange AKSA 100W Nirvana Modules

Gallery »
Browse gallery »
Albums by Lost81 »
Treble & Midrange AKSA 100W Nirvana Modules

Gallery

Treble & Midrange AKSA 100W Nirvana Modules

2 AKSA 100W Nirvana modules optimized for 110Hz and up...

Thumbnail for Monoblock #1. Elna Cerafine 100uF 100V replacing the stock capacitors (mounted outboard with zip ties and hot glue). A 0.04

Monoblock #1. Elna Cerafine 100uF 100V replacing the stock capacitors (mounted outboard with zip ties and hot glue). A 0.04" drill bit works perfectly to fit the leads of this larger capacitor. Watch the polarity!

Thumbnail for Closer look at Monoblock #1. You will need to enlarge the holes to fit the solid core 18AWG leads of the V-Cap. A needle file works best. Hint: scrap some of the solder mask off to create a larger solder pad for a more solid connection.

Closer look at Monoblock #1. You will need to enlarge the holes to fit the solid core 18AWG leads of the V-Cap. A needle file works best. Hint: scrap some of the solder mask off to create a larger solder pad for a more solid connection.

$Thumbnail for Monoblock #2. One cap is taller than the other due to a mistake bending the leads. Decided that an extra 5mm is not worth risking fracturing the solid core wire by re-bending it by 90 degrees.$

Monoblock #2. One cap is taller than the other due to a mistake bending the leads. Decided that an extra 5mm is not worth risking fracturing the solid core wire by re-bending it by 90 degrees.

Thumbnail for Closer look at Monoblock #2. Ground (green lead of the V-Cap) is closer on the left for both capacitors. I.e. lower impendence path to ground. Refer to your circuit schematic).

Closer look at Monoblock #2. Ground (green lead of the V-Cap) is closer on the left for both capacitors. I.e. lower impendence path to ground. Refer to your circuit schematic).

(Prev) | Page 1 | (Next)

View slideshow