Building a Paul Hynes SE1

Steps in building a Paul Hynes SE1 power amplfier using Depletion Mosfets.

front / back panels	A four way connector block used to connect the transformer windings to the PH regulators	Cables to the PH regs	A quick and dirty test of the mains plus regulator
and after a little fiddling - 12volts	12 volts feed to the amplifier 'board'	Inputs and outputs connected	Main connected to the switch
and the case earthed	the fuse revisited	more on the fused mains input	and case earthing

« Prev | Page 3 | Next »