Klipsch 504C upgrades

Gallery

Up to Albums by Shives

Klipsch 504C upgrades

Thumbnail for Some folks said that Danny did not give enough wire for the 504C kit. This is what I had left over! So, I do feel when setting up the crossover board, it would be ideal to combine the negative’s! And positives! This will allow for a single line input from and then easy to run your single from input - to tweeter - as you single main run. I used one single wire as well from post on board, to both speakers.

Some folks said that Danny did not give enough wire for the 504C kit. This is what I had left over! So, I do feel when setting up the crossover board, it would be ideal to combine the negative’s! And positives! This will allow for a single line input from and then easy to run your single from input - to tweeter - as you single main run. I used one single wire as well from post on board, to both speakers.

Thumbnail for Before the upgrade my AVR had a hard time finding a flat line! It looked like a roller coaster. After mods, I’d say this is flat! Being that’s proof this works. If the software could not find that line before, and now it can... thus showing us this nice flat line.. it works confirming with REW and some other ideas.

Before the upgrade my AVR had a hard time finding a flat line! It looked like a roller coaster. After mods, I’d say this is flat! Being that’s proof this works. If the software could not find that line before, and now it can... thus showing us this nice flat line.. it works confirming with REW and some other ideas.

Thumbnail for What happens when you mismatch kHz input settings. Apple was set to 48, REW sets to 44.1. Learn! Lol It’s overlaying the two measurements with wrong settings what can happen. My lower end showed a different result. Of course it will! Lol.

What happens when you mismatch kHz input settings. Apple was set to 48, REW sets to 44.1. Learn! Lol It’s overlaying the two measurements with wrong settings what can happen. My lower end showed a different result. Of course it will! Lol.

Thumbnail for So, I think the bottom end might be room mode, and casing some of this. This is taken in spot. And the location I feel most would say, ehh not great.

So, I think the bottom end might be room mode, and casing some of this. This is taken in spot. And the location I feel most would say, ehh not great.

« Prev | Page 3 | (Next)

SMF 2.0.19 | SMF © 2021, Simple Machines | Terms and Policies
XHTML
RSS
WAP2