Klipsch 504C upgrades

Wires! Drivers are both in series! Outer and inner. Tweeter is normal phase! Not reverse!	Negative shared, all heat shrinked!	Looking down and from behind. You can see how I ran my - together, this is common.. The wire is not for the woofers.. Please make that note! I used two different colors with the series wires.. making sure to mark the neg and pos of the wires that will be the same color in the same speaker hole.	You can see the box is cleaned up! Took forever with the glue they use. After no res I’m going to wrap the wires in foam tape. No rattle!!
7/16th hole, sanded down cup, installed and ready! Make sure you all position the female connection on both in the right orientation.	Nice!	Using some extra 2 part cheep glue, I used a little to make the back cup strong.. hoping it won’t vibrate as much. Overboard yes.	0CDF 7FCB-4085-4C 4D-BB 48-077FC 8609A 34
602AEDEA-6746-4C 13-959F-9D 5F 2E 8BD 115	(Untitled)	This is where I put the xover. I used some Polly under it to help (you see it sitting) then a piece over the xover. As well, I used Polly to fill gaps in the no res!	C 6D 04470-ABE 9-4D 56-81DD-D 2C 9159C 86BC

« Prev | Page 2 | Next »