Selah Canadian 3 way

The front and rear parts of the baffle glued together. Note the rear chamfer on the rear of the front baffle, to allow the woofer to breathe. I left extra material for the screws and to maintain some rigidity. It's all probably overkill but why not :)	The tweeter and mid holes cutout using a router and jasper jig.	Rear of the midrange driver cutout. With a 1.5inch front baffle and a small 5in driver, it becomes important to chamfer the rear of the cutout to allow the rear of the driver to breathe.	The crossovers installed
The dampening material installed	The front baffle glued in place	The woofer holes cutout with jasper jig, test fitting the woofer	Test fitting the drivers, so close now
Almost ready for the finish	Hardwood edges glued in	Edge glued in	Famowood walnut woodfiller

« Prev | Page 2 | Next »