DIY Electronics

1st Hagerman kit was the Bugle with a fancy case	Next I built a Cornet with switching but it hummmmmed badly	I went all out on the next Cornet to eliminate hum	Also incorporated Cinemag step-up transformers inside as both my cartridhes were low output
Had a mishap with a rectifier tube and blew up that Cornet!	While w/o a Cornet for quite awhile I built a Piccolo...	Also put the Cinemags in their own box	I was all set to make another chassis for a new Cornet...
...with shiny aluminum top plates...	...but in the end, I opted for the Lansing cases, and glad I did, because....	...I also built a Clarinet and positioning the controls is a whole lot easier! I also discovered that going exactly by the Hagerman book yields dead-silent operation at all volume levels.	My first non-kit build: this direct-coupled, single-ended, parafeed 45 main amplifier

(Prev) | Page 1 | Next »