ERS placement on power conditioners

Pics showing where I used ERS paper on power conditioners

A shot of the Powervar ABC600, ERS wrapped on the incoming power wires, back of the outlets and around the black "box" under the circuit board. Also notice that the outlets have been replaced with Hubbel deep cryo'd ones and I've bypassed the power switc	Closer detial view, can see some of the dynamat extreme, the lid is heavily damped with it as is the underside of the cabinet.	A little closer yet, with a better look at the ERS around the box between the donut and the outlets	A close detail view of the Oneac 1102, again on the back of the outlet and the "black box" I wrapped ERS paper.
A close view of the other side, again the outlet has been replaced with a deep cryo'd Hubbel.	A shot of the whole Oneac, an example of the amount of dynamat extreme I used and where I put the ERS on the lid.	Far away shot of the PS Audio Ultimate Outlet, stips on the lid, under the outlet and a couple pieces on the outlet. I used some extra smaller pieces on the left side you can see if you look closly.	Closer view of the ERS under and on the outlet of the UO.

(Prev) | Page 1 | (Next)