Carver Pro ZR1600

Carver Pro ZR1600 photos.

Occam By-Pass Mod - Signal Input Points, C201/202 Ch1 (upper center near connector - blue film & NP electrolytic) and C203/204 Ch2 (bottom right - blue film & NP electrolytic)	R246 & R247	Under Tunnel	Ch1 & Ch2 Signal Traces Going Under Wind Tunnel (fourth & fifth traces from the bottom of picture, see bottom of circuit board picture for "jumpers")
Ch1 & Ch2 Signal "Jumpers" are the two vertical traces about an inch long and 3/4 inch long near center of photo at bottom	ZR1600 Input Board Photo #1	ZR1600 Input Board Photo #2	ZR1600 Input Board Ch2 Side
ZR1600 Input Board Photo #3	ZR1600 Input Board Ch1 Side	ZR1600 Input Board Photo #4	ZR1600 Input Board Ch2 Side Closeup

« Prev | Page 3 | Next »