Hi Captainhemo,
Could you please give me the dimensions of the baffel for the monitor version? Thanks!
Best regards
Peter
Just over 27.5" (at center of top) x 13" x 1".
Then you have a 1.25" wing/side panel on either side.
What kind of tool complement am I going to need to put mine together?
Well, you're going to need a number of clamps, I would recommend at minimum 8 that will open at leat 13" as well as a few shorter ones you can use to clamp the inner sub walls/side panels at time of glue up. More is always better.
For the full kit, you'll need 32 3/8x3/8 N52 cylinder magnets as I posted above (link there).
You'll need a long punch of some sort to push the magnets ( way down into the braces and into the rear of the baffle ( these are not nearly as deep).
A hammer or rubber mallet of some sort for the above and to be sure dowels are seated... be gentle on the dowels.
Various grits of sandpaper, get a few sheets of 120, 220, and 320 /devent flat sanding block. A couple of those foam sanding blocks are handy for working the roundovers. How much a person does with regards to prep will greatly influence the finished cabinets.
Wood glue and either a small bottle of CA or something like Gorilla Glue for magnet installation.
Another person to help with glue up when the time comes
One of these days I'll post a couexploded views , one of the sub assembly, one of the full assembly to help with construction.
jay