Yarn mod question

0 Members and 1 Guest are viewing this topic. Read 2404 times.

HAL

  • Industry Contributor
  • Posts: 5174
Re: Yarn mod question
« Reply #20 on: 16 Jun 2019, 02:01 pm »
Impressive. So the front facet is what, about 10" wide? How much LF response are you getting out of the Neo 10's with the wing?

The front baffle is 10-7/8" wide.  The BG NEO10 planars go down to 200Hz where I put the XO to the servo subs.

josh358

  • Full Member
  • Posts: 1221
Re: Yarn mod question
« Reply #21 on: 16 Jun 2019, 02:12 pm »
Thanks.

scararabe

  • Jr. Member
  • Posts: 16
Re: Yarn mod question
« Reply #22 on: 16 Jun 2019, 07:31 pm »
Hello, how deep is the side wing?

HAL

  • Industry Contributor
  • Posts: 5174
Re: Yarn mod question
« Reply #23 on: 16 Jun 2019, 11:45 pm »
The line array side wing is 12" deep.

scararabe

  • Jr. Member
  • Posts: 16
Re: Yarn mod question
« Reply #24 on: 17 Jun 2019, 03:15 pm »
The line array side wing is 12" deep.

What is the thickness of the panel?
Have you had vibration problems?
Have you tried a deeper panel to reach a lower cutoff frequency?

emailtim

  • Full Member
  • Posts: 325
Re: Yarn mod question
« Reply #25 on: 4 Jul 2019, 10:44 pm »
...  And I don't know what you are using for digital crossovers, but I have tried quite a few and I am not a big fan of most of them. In fact the lower cost models sound really bad. ...

Hi Danny,

Have you heard digital XO's by Audiolense and/or Acourate ?  If so, any comments ?

TIA

Danny Richie

Re: Yarn mod question
« Reply #26 on: 4 Jul 2019, 11:07 pm »
Hi Danny,

Have you heard digital XO's by Audiolense and/or Acourate ?  If so, any comments ?

TIA

I haven't heard them.