How to Start a Purist Audio System

0 Members and 1 Guest are viewing this topic. Read 6241 times.

JLM

  • Full Member
  • Posts: 10696
  • The elephant normally IS the room
Re: How to Start a Purist Audio System
« Reply #20 on: 7 Jan 2024, 02:36 pm »
Start by educating your sense of hearing.  Music appreciation classes are a good place to begin.  Listen to unamplified music in places with good acoustics.  Get your hearing checked.  No point in spending gobs of money if you can't hear.

Set a budget.  Good systems that serve medium sized rooms can be had for $1000 retail, but won't go super loud or deep.  Avoid DIY that leads to proud papa bias which all audiophiles are guilty of anyway. 

Setup your listening space.  As I mentioned above the room shouldn't be squarish, small, or uninsulated.  Ideally it will be dedicated to listening.  My room is 8ft x 13ft x 21ft and well insulated.  It has a fiberglass exterior door with weather seal and flexible ductwork (can't hear the furnace).  It is treated with ten GIK 244 2ft x 4ft absorption panels plus three side wall tall bookcases (diffusors) that I can vary the "design" to suit.

Spend considerable time auditioning (months/years).  In many cases this would involve traveling, make a vacation out of it.  Bring 10 or more varied selections of what you love, including an audiophile guilty pleasure (poor recording) as the system needs to serve your desires.  Take written notes.  Only audition in a space that's similar to your room, not an open/noisy space.  Audition complete systems.  Insist on in-home trials. 

JohnR

Re: How to Start a Purist Audio System
« Reply #21 on: 8 Jan 2024, 02:02 am »
It would probably be helpful to begin by defining what a purist audio system is.

I can think of two definitions which lead to completely opposite approaches:
1. Focus on the hardware. This is FRM's approach. No crossover, simple circuits (except for the later comment about Class D, which surprised me), no boxes.
2. Focus on the result. This means measurements and (in my opinion and experience) active+DSP. But it's a longer road. Still, if I were starting again, that's where I'd start.

FullRangeMan

  • Facilitator
  • Posts: 20391
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: How to Start a Purist Audio System
« Reply #22 on: 8 Jan 2024, 03:04 am »
The summer is too hot for a tube amp, I forgot to consider that.

artur9

  • Full Member
  • Posts: 479
Re: How to Start a Purist Audio System
« Reply #23 on: 9 Jan 2024, 02:49 am »
Start by educating your sense of hearing.  ... Listen to unamplified music in places with good acoustics. ...
This, a thousand times this.  Otherwise, it's akin to making a space travel movie in the forties, when no one knew what the Earth looked like from orbit. 
https://www.thespacereview.com/article/3470/1

HST, electronica runs afoul of the "unamplified music" touchstone.

MC275V

  • Newbie
  • Posts: 2
Re: How to Start a Purist Audio System
« Reply #24 on: 4 Mar 2024, 08:10 pm »
As a longtime audiophile and music enthusiast, I feel that a “purist” system can be quite different for each person.  I also believe that your audio listening preferences can and will change over time.  If you listen to your system (or systems) often and enjoy it, you shouldn’t worry about it being purist.  I started my audio journey in the late 1960s with a Fisher tube receiver, ElectroVoice speakers and a Garrard record changer (which I only used manually for 33s).  By the mid 1970s I had moved to a solid state Sherwood receiver, Technics direct drive turntable and Sansui speakers.  By the early 1980s I had moved to Stereophile approved equipment, including HarmanKardon Citation power and preamp, Rega turntable, and Fried speakers.  By the 1990s I had B&K power amp, Musical Design tube preamp and Energy Pro22 Connoisseur speakers.  Today it’s McIntosh 275 amp, McIntosh C2200 pre, Clearaudio table, Harbeth speakers etc.  I’ve enjoyed each system throughout the years.  It’s been a fun experience for the last 50 plus years and I still listen every day. So, how to start a purist audio system; listen to live music, listen to as much equipment as you can, then purchase what you enjoy can afford.

sircrashalot

  • Jr. Member
  • Posts: 5
Re: How to Start a Purist Audio System
« Reply #25 on: 30 Oct 2024, 01:44 pm »
Hi to all,

I'm new to this forum and chose this circle to introduce myself because I'm always looking to improve my system's sound. I have been in the audio hobby for about one year, and as you might guess, already have a small collection of integrated amps, receivers, and of course, assorted speakers... most are second-hand and picked up locally. Every time I think I have an excellent sounding system, I find something that increases the SQ, although usually in small increments. Sometimes there are trade-offs: sometimes more clarity and detail at the cost of a little perceived bottom end, for example. I hope to learn more from you all. Thanks.

AllanS

  • Full Member
  • Posts: 612
Re: How to Start a Purist Audio System
« Reply #26 on: 31 Oct 2024, 01:23 am »
Every time I think I have an excellent sounding system, I find something that increases the SQ, although usually in small increments.
This could get to be an expensive hobby for you.  Welcome aboard!

Jon L

Re: How to Start a Purist Audio System
« Reply #27 on: 31 Oct 2024, 06:49 am »
Sometimes there are trade-offs: sometimes more clarity and detail at the cost of a little perceived bottom end, for example. I hope to learn more from you all. Thanks.

Careful shopping locally is a great way to build a nice system without spending audiofool money (and STILL not happy :oops:). 
If I were starting out today, I would go modular and separate bass from treble/mid.  For example, start with bass module using a vintage Alnico 12"/15" bass/mid driver with separate enclosure for treble/mid.  Reasonable Altec/JBL, etc horns with good compression drivers..