AudioCircle
Industry Circles => GR Research => Topic started by: Outofthewoods on 20 Apr 2013, 06:46 am
-
$1,900.00, plus shipping.
It's impossible to get good pics of it where I've got it stored. I will get some help and get it pulled out for better pics over the weekend.
It's the one in the picture being used as a center channel.
(http://i1187.photobucket.com/albums/z387/Outofthewoods/LS9_zps8b8f1b58.jpeg) (http://s1187.photobucket.com/user/Outofthewoods/media/LS9_zps8b8f1b58.jpeg.html)
Comes with a grille and base.
Ruben
-
Man, those are gorgeous Ruben
-jay
-
Man, those are gorgeous Ruben
-jay
They look good, don't they?!
That setup isn't mine, nor was it built by me. That is AC member Skimans system. He bought them from AV123. I just used his picture to show the speaker until I am able to take some myself.
I built him this Rosewood LS-C to replace the LS-9.
(http://i1187.photobucket.com/albums/z387/Outofthewoods/LS-C_zps68d7010d.jpeg) (http://s1187.photobucket.com/user/Outofthewoods/media/LS-C_zps68d7010d.jpeg.html)
(http://i1187.photobucket.com/albums/z387/Outofthewoods/RWStand4.jpg) (http://s1187.photobucket.com/user/Outofthewoods/media/RWStand4.jpg.html)
Ruben
-
Seven drivers for a center channel? I'm sure it's sounds good but why seven drivers? :scratch:
-
Seven drivers for a center channel? I'm sure it's sounds good but why seven drivers? :scratch:
Because it's a lot less than the 21 drivers in the center channel it replaced!
Steve
-
Seven drivers for a center channel? I'm sure it's sounds good but why seven drivers? :scratch:
Power handling and output capability to keep up with LS left and right speakers.
-
I'd be interested if I could find its maching pair. :duh:
-
I'd be interested if I could find its maching pair. :duh:
Or if Ruben could build a mate to it.
-
Yes 3 of those would be very nice indeed.
-
Yes 3 of those would be very nice indeed.
I should be able to start working on your triple 9's in about 6 weeks. :thumb:
I'll be in touch...
Ruben
-
Or if Ruben could build a mate to it.
The problem would be the veneer grain not matching. I could probably get it close though.
Also, if I were to build a mate it would cost a lot more than $1,900.00.
Ruben