I think it looks alright. But, seem folks are getting a bit confused on the tweeter.
I was actually talking and working with someone where the tweeter some how as he says has it’s post reversed. In other words, smaller was positive and larger was neg.
Normally large is positive, and smaller is neg. tho I’ve seen, maybe that’s not standard.. but most part I think it is. With Klipsch I’ve heard this twice now.
I only know how to test the mids and woofers with a 9 volt and watching what way it pops out to determine if polarity is correct. Tweeter having no movement... Any tips! Other then say REW?
Also what amp are you using? Does it have Room correction or DSP anything? If you do, make sure you re-do this.
If you have Audyssey... try setting it so it will only correct the lows, like 501 and lower.. or not. Make sure BBC is off! And it does not have a house curve so make sure you do one with the editor.
Other wise, all I got for tips. Double check your solder points for cold joints.
Take a few hours off,, walk away.. have some dinner or a drink. Later on go back and check it out. Danny has made a nice post about the full build and we have all added tips and tricks. Maybe read that and look at how those are done.