[Neo]

If you go with 3/4" + 1/4" thick panels, use a larger a roundover/radius on the left & right edges. The other edges aren't as important, but the top will help a little bit.

If you use 1/2" + 1/4" panels, you can use the standard recommended roundover/radius.

Thank you

[Neo]

Can anyone confirm the inside Dimensions of the Bravo?
Looks like 10 1/2" High X 6" Wide X 10" deep.

[Danny Richie]

Cabinet plans are on the site.

[Neo]

Making progress, intermittent and slow but having fun and moving forward. Learning about woodworking and how to use new tools, All good. Using a Walnut, Hard Maple and Red Oak pattern applied to MDF. I'm still hopeful I can pull off creating an acceptable looking and sounding cabinet.

[morganc]

Those are going to be stunning!   

[borism]

I love how the pattern plays with the eye creating a 3-D illusion!

[Neo]

morganc, borism, thanks for the encouragement.
 

[Neo]

Plan A Three D pattern was a failed effort. Gluing 1/4 inch cut hard wood end grain onto 1/2 inch MDF turns out is a real bad idea. The boards warped like lasagna noodles! All those clamps could not keep it all flat. A lot of work went into the dumpster. Should have just made a bunch of 3D Hard Wood end grain and cut them at 3/4 inch. A big time killer but Live and learn.
Plan B - 3/4 MDF with Cherry veneer. It is coming along, 2nd coat of oil based Satin clear varnish. X-overs soldered and ready for install. No-Rez applied. Can't wait to finish these so I can hear them.

[Neo]

Why do pictures upload sideways?
Any way to edit that?

[Hobbsmeerkat]

You need to edit them (i.e. crop them slightly) on your phone before uploading them. Or adding them directly to your gallery before sharing them here.

[Neo]

I'll try posing pictures again that are orientated correctly. These have been rotated in Gallery.

[Neo]

Need Tweeter gaskets. Tweeters sit slightly low.
Any suggestions on where to buy gaskets to correct how my tweeter sits in the cabinet?
Will this tweeter sitting a little low in the flange be noticeable if corrected?



 

[Neo]

Playing Music. Been playing overnight to break in.

[Neo]

Need Tweeter gaskets. Tweeters sit slightly low.
Any suggestions on where to buy gaskets to correct how my tweeter sits in the cabinet?
Will this tweeter sitting a little low in the flange be noticeable if corrected?

Received a suggested solution for my gasket question from a Butch. Thanks for the idea.