Hi Mike, I was reviewing your build thread again and have 2 questions I hope you can shed some light on.
#1.
I wondered why it looks like you used each LDR board for R+ and L+ then R- and L- on the other one. and if that's not case, maybe they're configured as R+ and L- and R- and L+? Either way, it seems that you have 1 signal from each channel on each board and I hope htat you ca nclarify a little about that.
#2.
Can you explain how the signal wires are coming off the volume pot? How are you not "dirtying the signal" when the pot should only have 1 "output". Not that I have a solid understanding of this, but it looks like you took 2 leads off the same pot, 1 to the LDR boards and 1 to the buffer boards. Is that right? I get that that might be the whole point of the buffer boards, but I'm kind of learning as I'm going here.