6l6 vs 300b - a few questions

0 Members and 1 Guest are viewing this topic. Read 5816 times.

Docere

Re: 6l6 vs 300b - a few questions
« Reply #40 on: 31 Dec 2022, 09:10 pm »
10,000 or perhaps even 40,000 hr
Well, this looks like exactly the WE site speech talk for its new 300B.

I have not seen the new WE site. My opinion is based on an older data sheet and a discussion with some engineers and audio friends probably over a decade ago. Running a quality 300B at 300V and circa 55mA, with reasonable care, might approach a 40K hr lifetime. Might. Even with a moderately higher dissipation, 10K hr might be achieved and is quite reasonable, I think.

YMMV.


FullRangeMan

  • Volunteer
  • Posts: 19849
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: 6l6 vs 300b - a few questions
« Reply #41 on: 31 Dec 2022, 09:58 pm »
This is quite extraordinaire at least, a friend with Dynaco 70 EL34 driving JBL L90 have to put new tubes at each 6/9 months.

Docere

Re: 6l6 vs 300b - a few questions
« Reply #42 on: 31 Dec 2022, 11:40 pm »
Different tubes and different use cases. I use my 2A3 tube amps for many hours daily (sometimes left on for days), for many years, and have not had to change an output tube (either JJ or EML). The EMLs were not treated kindly in one amp, probably have >5,000 hours on them now, and sound like new. I expect them to last for another decade at least, if I continue to use those amps.

I have been through a few pairs of nice NOS driver tubes though.
« Last Edit: 2 Jan 2023, 07:17 pm by Docere »

/mp

  • Jr. Member
  • Posts: 240
Re: 6l6 vs 300b - a few questions
« Reply #43 on: 1 Jan 2023, 09:36 pm »
I would not want to use them [300b] in parallel though.
Why? To what other tubes does this also apply?
TIA,

FullRangeMan

  • Volunteer
  • Posts: 19849
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: 6l6 vs 300b - a few questions
« Reply #44 on: 1 Jan 2023, 10:06 pm »
Four 300B are expensive and are hard pushed in parallel.

Docere

Re: 6l6 vs 300b - a few questions
« Reply #45 on: 2 Jan 2023, 01:55 am »
Why? To what other tubes does this also apply?
TIA,

My comments obviously refer to a SE topology, within reasonable power limits - just want to be clear about that.

A single 300B can provide enough power for a decent selection of speakers and listening preferences. Paralleling adds cost and complexity, and according to some, introduces sonic compromises (I don’t have an opinion about that).

If I wanted more power than a particular single tube can provide, I’d use a different single tube. Now, once our power needs pass a certain point, this becomes impractical.

Again, YMMV.

Kw6

  • Full Member
  • Posts: 471
Re: 6l6 vs 300b - a few questions
« Reply #46 on: 7 Jan 2023, 06:33 pm »
Yeah I would definitely find a speaker that only requires 8 watts to come alive. Or it has to be active like Daniel Hertz speakers designed by the Mark Levinson.
« Last Edit: 24 Jan 2023, 07:01 am by Kw6 »

Kw6

  • Full Member
  • Posts: 471
Re: 6l6 vs 300b - a few questions
« Reply #47 on: 24 Jan 2023, 07:05 am »
I have decided for me I am going to the 300b set route.I may get audio note kit interstage monos. 8 watts. What changed my mind. The availability of Chinese 300bs which sound decent. I can get match pr for $146 usd. Other big triodes generate too much heat and are expensive and I read 6c33c are very hard to get a match pr.

FullRangeMan

  • Volunteer
  • Posts: 19849
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: 6l6 vs 300b - a few questions
« Reply #48 on: 24 Jan 2023, 08:21 pm »
I read 6c33c are very hard to get a match pr.
Correct. This is solved by using auto-bias or manual bias, I use manual bias. Also 300B cannot use Self Adjusting bias.
« Last Edit: 25 Jan 2023, 12:01 am by FullRangeMan »

Kw6

  • Full Member
  • Posts: 471
Re: 6l6 vs 300b - a few questions
« Reply #49 on: 28 Jan 2023, 06:45 pm »
Ok I didn't know thanks! My Cayin 300b integrated uses the toggle switch to match up to centre of the metre to bias

does that count?

Kw6

  • Full Member
  • Posts: 471
Re: 6l6 vs 300b - a few questions
« Reply #50 on: 28 Jan 2023, 06:49 pm »
My comments obviously refer to a SE topology, within reasonable power limits - just want to be clear about that.

A single 300B can provide enough power for a decent selection of speakers and listening preferences. Paralleling adds cost and complexity, and according to some, introduces sonic compromises (I don’t have an opinion about that).

If I wanted more power than a particular single tube can provide, I’d use a different single tube. Now, once our power needs pass a certain point, this becomes impractical.

Again, YMMV.

Just like Jadis I300 300b in parallel for 10 watts. I'd rather have SET two 300b's for 8 watts. And a cheaper amp for customer.

FullRangeMan

  • Volunteer
  • Posts: 19849
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: 6l6 vs 300b - a few questions
« Reply #51 on: 30 Jan 2023, 01:59 am »
Maybe you want order the new Decware 300B $4,200 without tubes, with OPTs so small they are place under side.
https://www.decwareproducts.com/sarah

Kw6

  • Full Member
  • Posts: 471
Re: 6l6 vs 300b - a few questions
« Reply #52 on: 5 Feb 2023, 08:34 pm »
Fullrangeman I would like to but they never responded to me on YouTube and also heard they usually have a 2 yr wait! Can you confirm?

opnly bafld

  • Full Member
  • Posts: 2412
  • 83 Klipsch LSIs
Re: 6l6 vs 300b - a few questions
« Reply #53 on: 5 Feb 2023, 09:07 pm »
Over 2,000 orders on the Decware wait list, it will be a day or two or 700+.  :banghead:

FullRangeMan

  • Volunteer
  • Posts: 19849
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: 6l6 vs 300b - a few questions
« Reply #54 on: 5 Feb 2023, 09:24 pm »
Unbelievable.

Tyson

  • Full Member
  • Posts: 11087
  • Audio - It's all a big fake.
Re: 6l6 vs 300b - a few questions
« Reply #55 on: 5 Feb 2023, 09:51 pm »
Over 2,000 orders on the Decware wait list, it will be a day or two or 700+.  :banghead:

Sounds like they need to hire more people.

opnly bafld

  • Full Member
  • Posts: 2412
  • 83 Klipsch LSIs
Re: 6l6 vs 300b - a few questions
« Reply #56 on: 5 Feb 2023, 10:37 pm »
Sounds like they need to hire more people.

They have, but it's not easy finding help and their most experienced employee retired recently. Last I heard they are running 2 shifts.

Docere

Re: 6l6 vs 300b - a few questions
« Reply #57 on: 12 Feb 2023, 04:53 am »
I read 6c33c are very hard to get a match pr.
Correct. This is solved by using auto-bias or manual bias, I use manual bias. Also 300B cannot use Self Adjusting bias.

There seems to be some confusion of terms here... and it is not surprising, because the terms can be misleading!  :D The two most common ways of biasing an output tube are cathode bias (aka self-bias, self-adjusting bias) and fixed bias, which is usually adjustable (yes, that is correct) but is non-adjustable in some amps. The 300B can be biased using either cathode or fixed bias.

Kw6

  • Full Member
  • Posts: 471
Re: 6l6 vs 300b - a few questions
« Reply #58 on: 19 Feb 2023, 10:44 pm »
Ok thanks for sharing your thoughts! I agree with everyone that Decware need to hire some more hands!😅

Frankthetech

  • Jr. Member
  • Posts: 7
Re: 6l6 vs 300b - a few questions
« Reply #59 on: 13 Mar 2023, 01:14 pm »
Hi, a friend of mine brought over his 300b SE amp for me to test as he didn't like the way it sounded, I had a look an we hooked up a pair of my Klipsch tower speakers at 98 spl rating. No problem getting good volume out of this amp with these speakers. But the sound was not really great.
Replaced the input tubes with some new 6sl7 EH tubes and this made a big change, they will need burn in time. But as far as 300b amp being able to drive these speakers, no problem getting good volume. I agree you need speakers with a high spl, 90 or better. we did try a pair of Axiom bookshelf speakers at 90 spl and they worked ok too.