GRS 10SW-4 10 Box Configuration

JCarney · « **on:** 10 Feb 2024, 06:54 pm »

I have a GRS 10SW-4 10" driver I would like to put in a 1.25cuft vented enclosure as recommended by PE. I cannot find anything more on the enclosure other than the volume. My question is there are a couple of general sets of plans for what seems to be a generic 10" driver that I have found for both sealed and vented, but I'm not sure how to proceed. Would a generic plan just be a waste of time? Do I go ahead and do the 1.0cuft sealed enclosure? I do have more, but I'll wait to see if I get lucky and someone has worked with this driver. I'll include a link to PE for the driver specs, just scroll down past the description. I have a Dayton 100w digital plate amp to drive it.

Thanks,
JCarney

https://www.parts-express.com/GRS-10SW-4-10-Poly-Cone-Subwoofer-4-Ohm-292-482?quantity=1

hdspeakerman · « **Reply #1 on:** 13 Feb 2024, 08:27 pm »

You might do better on PE forum.

JCarney · « **Reply #2 on:** 13 Feb 2024, 10:07 pm »

Thanks hd, good idea.

JCarney

JCarney · « **Reply #3 on:** 13 Feb 2024, 10:31 pm »

I registered at PE for the forums. I cannot figure out how to post a new topic. I looked at the help section and it said I may need special permission for my first post. How does on go about getting said permission. Not at all easy to navigate.

Thanks,
JCarney