AudioCircle

Audio/Video Gear and Systems => Owner's Circles => Bent Audio Owners => Topic started by: Sonny on 13 Mar 2009, 01:06 am

Title: Deleted...
Post by: Sonny on 13 Mar 2009, 01:06 am

Deleted

Title: Re: WIRING - BENT ALPS REMOTE MODULE _ HELP_!!!
Post by: John Chapman on 13 Mar 2009, 03:21 am

Hello!

I don't think you'll get much help out there on that one.... That unit was a prototype unit and aside from a few others here in my shop it may be the only one like it in the world. It was a BSA-1 PCB (done for goldpoint) that was run from an ALPS motor pot. Something we thought we'd do with goldpoint but now in typical engineering fashion we are on to a new design..... It was kinda fun.   It was tossed in the box with your pre-amp as I recall - kind of a beta test unit! I sent an e-mail to you tonight - hope you got it. I will dig out one of the others tomorrow and then we'll get it going I am sure or I'll fire you down something else to put in it's place.

Thansk!

John

Title: Re: WIRING - BENT ALPS REMOTE MODULE _ HELP_!!!
Post by: Sonny on 13 Mar 2009, 05:16 am

Thanks John... :thumb:

And as always...what service! :thumb: :thumb: :thumb:

Title: Re: WIRING - BENT ALPS REMOTE MODULE _ HELP_!!!
Post by: Sonny on 18 Mar 2009, 03:35 pm

Sorry for the late posting, but the ALPS is now working, it sounds great and is a wonderful little attenuator, remote to boot!

I'd recommend it anyone who is looking for a great single input attenuator with remote!

Thanks JOHN!

Tuan

Title: Re: WIRING - BENT ALPS REMOTE MODULE _ HELP_!!!
Post by: John Chapman on 20 Mar 2009, 04:39 pm

Hello!

Glad it is alive and that you are having fun with it!

Thansk!

John