Okay, I measured a group of them and the measurements looked real good. I think the consistency is a little better than the ones I used to get from BG. And the responses sure look good in the NX-Otica baffle with wave guide that I was measuring them in.
BG made these in two versions. There was a standard version that had five rows of magnets and then a pdr version that only had three rows of magnets and a row of felt filling the two outside rows on both sides. The pdr version had reduced sensitivity due to less motor strength. Also, the added felt on the sides falls under a patent that BG owned. And it is now owned by new owners, Christy Digital.
What I had BG do for me was build a base unit with all five rows of magnets but add the felt to the front side only. This gave the improved off axis response of the pdr version while keeping the higher sensitivity of the base model.
So for the new GR Neo 3 I also had them build these as base models with all five rows of magnets. So sensitivity is kept high.
![](http://gr-research.com/pics/gr%20neo3a.jpg)
I had the connectors made from Copper instead of Tin and the film is the yellow colored Kapton instead of Kaladex. Also, the thin felt mounted to the diaphragm is white instead of black. So they are easily identified as the new GR Neo 3.
![](http://gr-research.com/pics/gr%20neo4.jpg)
Now if I sell them with felt on the outside rows like the pdr version from BG then I am opening myself up for a patent suit. So they will be sold as seen here and open in all rows, front and back.
However, my testing reveals that a thick black yard feed through the outer rows produces the same effect and response as the felt used in the BG models.
![](http://gr-research.com/pics/gr%20neo3b.jpg)
So I can supply the tweeters and the yarn, but you guys will need to install the yarn yourselves. It is quite easy though.
Just wrap a little tape around the end of the yarn so that you can feed it through the outer rows.
![](http://gr-research.com/pics/gr%20neo3c.jpg)
Sliding it through with a toothpick is very easy. And then just pull it up and out in the end.
Then just trim off the tape on the end and push the end down into the outer hole using the end of a zip tie.
![](http://gr-research.com/pics/gr%20neo3e.jpg)
Then trim the other end off and do the same.
![](http://gr-research.com/pics/gr%20neo3f.jpg)
It's pretty easy and just takes a few minutes. Just don't use anything magnetically conductive or the magnets will try and grab it.
And even though these are an improved version of the tweeter I can still come in on the price just under the sales price of the BG Neo 3. So I'll be listing them for $85 each.