[HT1278]

For the X-On wall, where is the best place to put the crossover?

Wanted to put NoRez in but then I was debating on where the crossover would go. 

     Also does anyone have a cut sheet for the No Rez for the X-CS or the X-On wall?

It was very much trial and error for me putting No Rez in the X-LS that I just did.

My flatpacks are from Denton Woodworkers. 

Here is an image of inside the X-LS.

[Vince in TX]

I actually placed my crossovers before I installed the no-res.   I put them center (between the drivers) below the cup.

EDIT:  Side note, I didn't use a cut sheet.   I just measured each space and rough cut it on the fly.

[Danny Richie]

What you did is fine.