« previous next »
Pages: [1]   Go Down

Socket size needed to remove the plinth bolts on STs?

0 Members and 1 Guest are viewing this topic. Read 1096 times.

billmcc

  • Full Member
  • Posts: 408
Socket size needed to remove the plinth bolts on STs?
« on: 10 Oct 2013, 01:02 pm »
I'm helping a friend break down and ship their Veracity STs this morning. I can't recall the socket size I used to apply the lag bolts on the plinths of my STs. Anyone recall what size socket is needed? I have my STs positioned just right and would prefer not to move them to check. Thanks :)!

Bill
Logged

Big Red Machine

Re: Socket size needed to remove the plinth bolts on STs?
« Reply #1 on: 10 Oct 2013, 01:17 pm »
I think it is 1/2 inch.  I believe all the plinths use the same screws.  If not 1/2 then 9/16.
Logged

J Fallows

  • Jr. Member
  • Posts: 109
  • melomane
Re: Socket size needed to remove the plinth bolts on STs?
« Reply #2 on: 10 Oct 2013, 02:40 pm »
The lag bolts are 5/16 x 2 1/2". It takes a 1/2" socket to unscrew them. 13mm works too.
Logged

billmcc

  • Full Member
  • Posts: 408
Re: Socket size needed to remove the plinth bolts on STs?
« Reply #3 on: 10 Oct 2013, 09:36 pm »
BRM and J Fallows,

Thank you very much for your help :). They are in fact 1/2" and everything worked out fine!

Bill
Logged
Pages: [1]   Go Up
« previous next »