AudioCircle
Other Stuff => Archived Manufacturer Circles => DIY Cable => Topic started by: Kevin Haskins on 3 Mar 2010, 05:09 pm
-
I sent a couple Anarchys to Voice Coil for review. Voice Coil is more of an industry trade magazine for audio engineers than it is a consumer level gear reviewing publication so the review is heavy on measurement and engineering details, short on opinion. I know that appeals to some and not to others. To do a subjective review you have to use it in a design so I'll leave that to others and eventually I'll get around to doing a finished loudspeaker using them.
But... for those who like to look at wiggly lines and try and interpret them, here is the skinny.
http://www.audioamateurinc.com/digital/vc/issue/310/
Pages 16-23
If you have any questions about the measurements or the design choices used in the driver this is the place to ask.
-
Kevin:
Looks good. Any hints as to when we'll see a new speaker design using them?
Cheers, kfr
-
At some point I'll get around to designing some speakers. Right now I'm in the middle of another project and I just don't have the time. The plan is that I'll have some completed speakers not kits. I already have a monitor design done using the Hypex DSP based system and I'd like to leverage that to do a tower and perhaps a dipole.
-
Mr. Haskins,
I was unable to locate the PRAT Graphs. :green:
Best Regards,
TerryO
-
Mr. Haskins,
I was unable to locate the PRAT Graphs. :green:
Best Regards,
TerryO
Well Terry... I've done some research and I've found a way to measure PRAT. Maybe I should say that I've found a way to insure it. It is a trade secret though and it involves the use of illegal substances so I'm not sure how valuable it is on a commercial basis anyway.
-
So are these wires useful for winding speaker voice coils?
I am wondering.
Frank