Port Configuration - XLS Encore (Rear Port)

0 Members and 1 Guest are viewing this topic. Read 116 times.

ButchWillard

  • Jr. Member
  • Posts: 8
Port Configuration - XLS Encore (Rear Port)
« on: 21 Jul 2021, 05:32 pm »
Rear Port configuration.  Almost finished with my XLS Encore build.  I'm sure this is a silly question but want to ask before I install the ports.  My ports have a cross inside the rear of the port vs. a completely open cylinder.  Does it matter?  Thanks

Norman Tracy

  • Industry Participant
  • Posts: 362
    • Audio Crafters Guild
Re: Port Configuration - XLS Encore (Rear Port)
« Reply #1 on: 21 Jul 2021, 06:08 pm »
Not a dumb question. The cross is from the plastic molding injection process when the ports are made. Cut out to open port before installing.

ButchWillard

  • Jr. Member
  • Posts: 8
Re: Port Configuration - XLS Encore (Rear Port)
« Reply #2 on: 21 Jul 2021, 06:09 pm »
Thank you!