AudioCircle
Industry Circles => GR Research => Topic started by: stupac62 on 14 Jul 2021, 08:39 pm
-
I'm very new to all of this and have been researching. So don't presume I know anything haha.
I'm looking to build out a home theatre. The end goal is a 7.2.4 setup. But I'm going to grow into it by going 5.1 first. I was thinking X-CS encore for center channel, but am not sure if I should go with X-MTM or X-SLS for left and right channel?
Here is what I'm thinking for my initial 5.1 setup:
- center: x-cs
- left/right: x-mtm or x-sls?
- surround: the mini
For the eventual 7.2.4 setup:
- center: same as above
- left/right: same as above
- all surrounds and rears: x-ls
- height: the mini
Are X-LS encores the right choice for surrounds in me end goal setup? Also, I'm not sure about the height speakers at all. Thanks.
-
I would suggest X-CS Encore for the front three channels.
-
I'm pretty much in the same market, except I'm using NX STUDIO'S up front. Open for suggestions for Rear channel speakers for initially starting out with a 5.1 HT arrangement, eventually changing to a 7.2 configuration. Open to suggestions too! Thanks
I'm very new to all of this and have been researching. So don't presume I know anything haha.
I'm looking to build out a home theatre. The end goal is a 7.2.4 setup. But I'm going to grow into it by going 5.1 first. I was thinking X-CS encore for center channel, but am not sure if I should go with X-MTM or X-SLS for left and right channel?
Here is what I'm thinking for my initial 5.1 setup:
- center: x-cs
- left/right: x-mtm or x-sls?
- surround: the mini
For the eventual 7.2.4 setup:
- center: same as above
- left/right: same as above
- all surrounds and rears: x-ls
- height: the mini
Are X-LS encores the right choice for surrounds in me end goal setup? Also, I'm not sure about the height speakers at all. Thanks.
-
If you are going with the X-CS center I’d recommend the X-MTM since it uses the exact same drivers and won’t require stands.
-
The MTM towers also can play much lower than the sealed X-CS cabinets are capable of.
-
Thanks all for the feedback. I think I'll go for the MTMs for the left/right channel.