[dareelbo]

Hi All,

Does anyone have any experience debugging IcePower procetction alerts through LEDs?
My center channel Icepower 200asc is blinking its standby LED with the green LED staying on.
It doesn't feel hot.
Wires Dont look shorted.
And there's no waveform/frequency signal being sent to the center channel.
(those cover the 3 types of protection circuit alerts the module has.)

I'm kind of stumped as to what it may be.

Anyone have any ideas or experince with this?

[Norman Tracy]

Has anything changed with the attached speaker? Flashing power LED can indicate bad load placing amp into protection mode.

[Doublej]

I would move the center channel speaker to another channel on the amp and see if the problem follows the speaker or stays in the center channel.

[dareelbo]

Nothing has changed that I can tell. Wiring looks identical as when I first installed a couple of weeks ago.

Good idea about switching the wiring and seeing if the problem follows the speaker or center channel. I'll try that next.

[dareelbo]

Switched the wires. Problem followed the speaker.
Looked further into the wiring at the speaker back.
Center channel negative lead was unplugged. (doh!)

Thanks for the help guys.

[Doublej]

Been there many times. Good to hear that all your gear is working fine.