AudioCircle

Industry Circles => GR Research => Topic started by: BlindFalcon on 27 Mar 2024, 07:03 pm

Title: LGK 2.0 Crossover Check
Post by: BlindFalcon on 27 Mar 2024, 07:03 pm

Hey Gang.  Just getting around to building my LGK 2.0's.  I'm organizing the crossovers using a post by E-ZEE.  Can someone let me know if this is good before I start soldering.  I don't know electronic symbols, so I used "S" for speaker, and "I" for input.  Can someone tell me what "W" stands for? 

Also, is it OK to put the large coil towards the front.  If I put it in the back it interferes with the connectors.  I could mount the connectors high though.  Picture attached.

Thanks!


(https://www.audiocircle.com/image.php?id=262780)


(https://www.audiocircle.com/image.php?id=262781)


(https://www.audiocircle.com/image.php?id=262782)

Title: Re: LGK 2.0 Crossover Check
Post by: fre11111 on 28 Mar 2024, 10:39 am

Hi Blind Falcon,

Dont forget to strip the red coating in the Inductor leads. I am not sure if it is just the photo but it seems that the big inductor needs to be stripped. You can use sandpaper, a cutter or a dremel tool. Thanks.

Frederick

Title: Re: LGK 2.0 Crossover Check
Post by: BlindFalcon on 28 Mar 2024, 06:49 pm

Thanks Frederick.  I'll definitely strip the red coating off before soldering.  I haven't made that connection yet as I'm planning on slipping a piece of shrink tubing up on the solder joint higher up on that lead.  I need to start building the cabinets.  Out of town this weekend, but by next week things should start to happen.

Title: Re: LGK 2.0 Crossover Check
Post by: fre11111 on 29 Mar 2024, 04:11 am

Let me know if you have any questions, just send me a PM and I will help anyway I can.

Frederick