[HT1278]

Getting ready to build X-On wall speakers, what is a good way to clamp the angled wood?

With this ans the X-CS is setting Titebond Extend (slow setting) glue better than the regular Titebond?

I built a Encore X-LS today and I think I would have been better off with the slower setting glue.   

I was taking so long that it became hard to put the top in after the sides were glued.   I am so green to this. 

So far I built a set of LKG 2.0's and one Encore X-LS.
Original?

[HT1278]

That should be a . , not a question mark at the end of the sentence.   Lol

[HT1278]

Picture from the encore X-LS build today.

The top, front and back were difficult after sides and front went on though.

[Vince in TX]

Did you buy the flat packs from Danny's web page, or are you having them cut yourself?   The flat packs came pre-assembled since they are a challenge to put together yourself.

[HT1278]

I ordered the X-On wall flatpacks from Danny's website.   They came unnasembled. 

I am going to clamp them down with Bessey strap clamps.   

Built both X-LS, and a pair of LGK 2.0 cabinets.  I need to build a pair of X-On wall's, and a X-CS.