« previous next »
Pages: [1]   Go Down

Spikes Thread Size

0 Members and 1 Guest are viewing this topic. Read 2031 times.

Captainhemo

Spikes Thread Size
« on: 4 May 2016, 01:01 am »
I have some inserts that fit the spikes Dany carries, I know they are 8mm.... does anyone know if they are designated course or fine  ?  I have someone  wanting to  use some casters  , not sure what   to tell him to buy

No metric tap/die set to check....

jay
« Last Edit: 4 May 2016, 02:40 am by Captainhemo »
Logged

mlundy57

  • Industry Participant
  • Posts: 3579
Re: Spikes Thread Size
« Reply #1 on: 4 May 2016, 03:47 am »
Jay,

They certainly look course to me. You could always pick up two 8mm bolts, one course and one fine, at your local hardware store to confirm.

Mike
Logged

Captainhemo

Re: Spikes Thread Size
« Reply #2 on: 4 May 2016, 04:00 am »
Yeah, I'm pretty sure they are course, I  just didn't want the fellow to  end up buying the wrong the casters.
If someone doesn't  have the answer, I may just end up   hitting the  HW store as you suggest

How did things go at LSAF  ?
Logged

bdp24

  • Full Member
  • Posts: 884
Re: Spikes Thread Size
« Reply #3 on: 4 May 2016, 06:59 am »
They're coarse, of course ;-).
Logged

lacro

  • Full Member
  • Posts: 602
Re: Spikes Thread Size
« Reply #4 on: 4 May 2016, 01:37 pm »
Jay,
M8x1.25 is the most common thread pitch. 1.25 millimeter is the distance between 2 thread peaks (^^) So the distance between 8 thread peaks (^^^^^^^^) is 10MM which shouldn't be too difficult to measure. A thread pitch gauge makes life easier.
http://www.amazon.com/Metric-Screw-Pitch-60-Degree-0-5-7-0mm/dp/B0079G3IIY/ref=sr_1_8?ie=UTF8&qid=1462368907&sr=8-8&keywords=thread+pitch+gauge+metric
Logged
Pages: [1]   Go Up
« previous next »