I am an electronics tech but am still having the same issue from the breathtaking lack of any instructions. Mine came with 4 sonicaps and 2 miflex. Here is what I came up with- the 12uf sonicap replaces c6 with the miflex soldered in parallel, to the sonicap leads. the 20 replaces c9 with the miflex in parallel. I dont see a 33uf polycap for the.68 sonicap nor can I tell for sure if the sonicap replaces or is in parallel. there is only one electrolytic cap, but its showing it in these "instructions' as either 80 or 100 and again is the .82 sonicap in parallel? It looks like it but does't say. In fact it says nothing about removing any caps or swapping caps around. Finally on the mids and woofers it looks like you guys are putting both sets of wires into the board. Can anyone please provide some clarity.
Both Tweeter caps get replaced with Sonicaps and Miflex in parallel.
The small 0.1 uF Sonicaps can be removed.
The 0.68uF Sonicap replaces C4 (it bypasses the standing 33uF cap)
The 0.82uF Sonicap is put in parallel across the 20uF cap next to the red electrolytic capacitor.
You wire the drivers in parallel by either one set of wires from crossover to one woofer, then wires jumping from that woofer to the other.
Or, you can have 2 sets of wires coming from the crossover board, with one pair of drivers going to each driver in that circuit.
Whatever you think works/looks best is fine.