Hi all,
so I have the JE LABs panels and was wondering what would be some options to make this smaller or easier to integrate in the room.
The options I would like feedback on are:
1) bring the width down to just slightly more than the driver diameter and fold back the orignal baffle suface sort of making sides either at right angle or some angle maybe with piano hinges.. in short no top but deeper sides and narrow baffle still sitting on the floor like original at an angle.
2) raise the driver way up to say ear level when sitting down on a board that is slightly wider than driver but no sides this time, like a narrow tomb stone if you get the picture with the driver near the top.
I know that both probably compromise the bass even more but maybe I can back fill with two small subs, especially in option 2 as the subs might fit perfectly below the driver, behind the front board and actually act as a weight holding down the thing.
in both cases, I hope the narrower baffle helps with the stereo image.
thanks for the tips
/paba