"Press/hold encoder for between 3-5 seconds and release - turns unit off - light is off
Unit is now off - light is off"
I tried this a few times and each time the light flashes on and off rather quickly and just continues to do so till I push it in again, then the light just stays on.
Can`t get it to go off no matter what.
Interestingly enough if I push the 'Power' button on the remote the light flickers real fast for a second or two THEN the light does go out.
Is there a glitch somewhere you think ?
And thanks again.
Steve
Glitch highly unlikely. Timing matters. What you are describing is consistent with B.2.ii
To recap.
A) When off (no light)
1) Press/release - turns unit on - light steady on
2) Quarter+ turn - turns on auto-cal - light blinks
B) When On
1) Press/release - toggles mute on/off
2) Press/hold/release
(i) At least 3 but no more than 5 seconds - turns unit off - light goes off
(ii) At least 5 seconds but no more than 10 seconds - puts unit in balance adjust mode - light flashes quickly
(iii) At least 10 seconds but no more than 20 seconds - resets channel balance - light flashes briefly and then remains on
(iv) At least 20+ seconds - puts unit in IR remove "pairing" mode - light flashes very quickly